ATN Zebra 16, Operator'S And Safety Manual

Page: 51 / 80

OPERATOR AND SAFETY MANUAL
1NO0035UK-05
Zebra 16 51
MARKER DESCRIPTION NB. CODE OPERATION INTERVALS
LUB. PTS
D 50
(1)
200H 400H 1200H
1 Hydraulic tank 1 H46
Level check
(5) X
Oil change
X
(2)
2 Hydraulic filter (Return) 1 - Filter element replacement
X X
3
Hydraulic filter (Medium
pressure on transmission
pump)
1 - Filter element replacement X X
4 Engine oil 1 HM
Level check
X
Oil Change
X X
(3)
5
Engine oil filter 1 -
Replacement X X
(3)
6
Diesel filter 1 -
Filter element replacement X X (3)
7
Diesel pre-filter 1 -
Replacement X
8 Fuel tank 1 - Sediment drainage and cleaning X
9
Cooling fluid 1 -
Level check X
10 Air filter 1 -
Cleaning
X
(4)
Filter element replacement X
(3)
15
Oscillating axle cylinder
grease nipples
4
GR
Application: Grease gun X
16
Grease nipples
– Arm
pins
4
GR
Application: Grease gun X
17
Arm 1 synchronisation
tie-rod greasers
2
GR
Application: Grease gun X
18
Lift cylinder grease
nipples
2
GR
Application: Grease gun X
19
Load control system
greaser nipples 4
GR
Application: Grease gun X
20
Turntable bearing teeth
1
GR
Remove the used grease
Application: Brush
X
(6)
21
Turntable bearing grease
nipples.
2
GR
Application: Grease gun X (6)
22
Grease nipples turntable
worm gear reducer
3
GR
Application: Grease gun X
(6)
Notes:
J: At the beginning of each day or after each operator change.
(1): After the first 50 hours' operation.
(2): At the interval indicated or every 2 years.
(3): At the interval indicated or every year.
(4): The air filter body has a clogging indicator. Clean the filter if the indicator turns red before
the indicated interval.
(5): The oil level must appear in the level light window.
(6): Turn the structure to distribute the grease.
7.3. WHEELS
The wheel tightening must be checked after the
first 50 hours' use and then every 3 months or
every 100 hours' operation.
•
Wheel replacement
To avoid harming the machine's stability, the wheels may only be replaced by wheels with
identical characteristics (dimensions, load capacity, crushing under load, true position, mass,
etc.).
CAUTION
DO NOT USE AN IMPACT WRENCH TO
TIGHTEN THE WHEEL NUTS.