Using the AT85DVK-07 Board
2-8
AT85DVK-07 Development Board User Guide
4391B–MP3–07/07
2.2.4
Power Configuration
The power configuration is done through a set of solder straps. By default, the
AT85DVK-07 Board is delivered configured in “Low Voltage 3V application” meaning all
external components (LCD, NF, MMC…) are powered at 3V.
Note:
“Very Low Voltage 1.8V application” uses the on-chip 1.8V DC-DC of the
AT85C51SND3Bx while “Low Voltage 3V application” uses the external on-board DC-
DC.
Table 2-5.
Power Configuration
Notes:
1. Option to allow battery voltage monitoring by the AT85C51SND3Bx.
2. Option to allow power key-press detection by the AT85C51SND3Bx.
3. Remove this connection when using a daughter board DC-DC extension.
Figure 2-5.
Very Low Voltage Application Power Configuration
Solder Strap
Very Low Voltage
Application
Low Voltage
Application
Comment
SE32
X
VDD selection amongst HVDD or LVDD
SE34
X
SE33
X
AVDD2 selection amongst HVDD or LVDD
SE35
X
SE37
X
X
(1)
Internal / External DC-DC V
BAT
Selection
SE38
X
(3)
SE56
X
(3)
On-board DC-DC output insulation
SE57
X
X
(2)
Power-on switch routing
SE58
X
S
E
3
5
AAA Battery
S
E
3
3
S
E
3
2
S
E
3
4
S
E
5
6
SE57
SE58
L5
Socket
Bottom View
Top View
SE38
S
E
3
7
J20
