Evaluation Kit AT697F V3.0 [APPLICATION NOTE]
8
Figure 2-3. Front panel overview
2.3
Manufacturing configuration
The Evaluation kit embeds a DIP switch allowing the user to configure several parameters. During this application note,
the switch is named SW37 and the switch number of the device is named with a “.x”. The following array describes the
initial configuration:
Figure 2-4. Configuration switches
Table 2-1 Initial configuration state
Name
Initial state
Function
SW37.1
OFF
Actives EDAC
SW37.2
ON
Actives the Bypass (thus disable the PLL)
SW37.3
OFF
SKEW 0 configuration
SW37.4
OFF
SKEW 1 configuration
SW37.5
OFF
Connect the processor watchdog to the RESET device
SW37.6
OFF
Select the processor clock.
SW37.7
OFF
This switch will select the PROM width.
SW37.8
OFF
Select PIO3 signal.
SW37.9
OFF
N.C.
SW37.10
OFF
N.C.
Processor
state
Power supply
state
ADC Ch 1
(Unused)
JTAG
Connector
Reset
Button
UART 1
DSU
Connector
SPP
Connector
Processor
Ext clock
UART
Ext clock