448
32072H–AVR32–10/2012
AT32UC3A3
Figure 22-4. Transfer Format
22.8.2
Operation
The TWIS has two modes of operation:
• Slave transmitter mode
• Slave receiver mode
A master is a device which starts and stops a transfer and generates the TWCK clock. A slave is
assigned an address and responds to requests from the master. These modes are described in
the following chapters.
Figure 22-5. Typical Application Block Diagram
22.8.2.1
Bus Timing
The Timing Register (TR) is used to control the timing of bus signals driven by the TWIS. TR
describes bus timings as a function of cycles of the prescaled CLK_TWIS. The clock prescaling
can be selected through TR.EXP.
TR has the following fields:
TLOWS: Prescaled clock cycles used to time SMBUS timeout T
LOW:SEXT
.
TWD
TWCK
Start
Address
R/W
Ack
Data
Ack
Data
Ack
Stop
Host with
TWI
Interface
TWD
TWCK
Atmel TWI
Serial EEPROM
I²C RTC
I²C LCD
Controller
Slave 1
Slave 2
Slave 3
VDD
I²C Temp.
Sensor
Slave 4
Rp: Pull up value as given by the I²C Standard
Rp
Rp
f
PRESCALED
f
CLK_TWIS
2
EXP
1
+
(
)
-------------------------
=
Summary of Contents for AT32UC3A3128
Page 61: ...61 32072H AVR32 10 2012 AT32UC3A3 PLLEN PLL Enable 0 PLL is disabled 1 PLL is enabled...
Page 592: ...592 32072H AVR32 10 2012 AT32UC3A3 Manchester Configuration Register on page 614...
Page 989: ...989 32072H AVR32 10 2012 AT32UC3A3 37 2 Package Drawings Figure 37 1 TFBGA 144 package drawing...
Page 991: ...991 32072H AVR32 10 2012 AT32UC3A3 Figure 37 3 VFBGA 100 package drawing...
