S
IGNUM
S
YSTEMS
C
ORP
.
JTAG
JET
-ARM
JTAG
JET
-T
RACE
C
ONTACTS
USA
Signum Systems Corp.
11992 Challenger Court
Moorpark, CA 93021 - USA
Phone:
+1 (805) 523-9774
Fax:
+1 (805) 523-9776
EUROPE
e-mail: [email protected]
ASIA/JAPAN
e-mail: [email protected]
II-11
Celebrating 25 years of emulation systems design!
JTAGjet-ARM
is a non-intrusive In-Circuit
Debugger for all AT91 ARM7 and ARM9
based devices. It features:
•
High-speed USB 2.0
(480 Mbps) interface
allows downloading to target RAM at rates
exceeding
1 MBytes/sec
.
•
Chameleon Debugger
for ARM7 and
ARM9 with integrated NOR and NAND
Flash Programmer
.
•
AT91 Peripheral device register window
gives detailed information about register
bits, bit fields and their descriptions.
•
Based on high-speed logic (FPGA)
JTAGjet is optimized for fast downloads, fast
window refreshing and instruction stepping.
•
Support for all popular (over a dozen)
3rd
Party Debuggers & Compilers
.
•
Up to 30 MHz JTAG
clock with
Adaptive
Clock support (RTCK).
•
Virtual-to-physical address mapping
support for ARM cores with MMU
(essential for WinCE, PalmOS, OSE or
Linux operating systems).
•
JTAG chain diagnostics
for device
detection, identification and troubleshooting.
•
Active JTAG probes
support long and noisy
JTAG chains.
JTAGjet-Trace
has the same features as
the JTAGjet-ARM but adds
real-time trace
memory.
•
Supports the
AT91RM9200
and other
devices that contain the
ETM
(Embedded
Trace Macrocell) trace port.
•
Non-intrusive trace capture at up to
400 MHz
CPU speeds.
•
Up to 4M frames deep
trace memory
(18 MBytes) captures the entire
program
flow
(PC) and all
data transactions
(variables and CPU registers) in real-time.
•
56-bit, cycle-accurate time-stamp
is
added to each frame to show detailed
execution timing as well as frequency of
execution of any function or interrupt.
•
Pre- and post-capture trace filtering
with
simple and intuitive user interface.
•
Export trace data to Excel
file for further
analysis and graphing.
•
Quiet operation
- no heat problems,
no fans.
•
One connection to target
via the
standard 38-pin Mictor connector.
•
Single, palm sized unit
- both the emulator
and the trace are in one enclosure.
•
USB 2.0 interface
•
Supports all major debuggers
•
Integrated Flash programmer
•
Multi-core support
•
Cycle accurate trace up to 400 MHz
•
Up to 4M frame deep trace
•
56-bit time stamp, cycle accurate
•
ETB support
C
H
A
P
T
E
R
I I
- J T A G I C E
I
N T E R F A C E S
5C46 AT91 3Party BAT.xp 7/09/05 2:52 Page 28
