AT-OME-MS42
34
Device Operation
Once set to
Follow USB
mode, the AT-OME-MS42 will exhibit the following behavior:
•
If only one USB host port is connected, then the AT-OME-MS42 will use the USB host device connected to
that port.
•
If an another USB host device is connected to the vacant USB host port, then the AT-OME-MS42 will
automatically switch to that USB host device.
• If
both
USB 1
and
USB 2
host ports are connected, then the AT-OME-MS42 will switch to the USB port that
was connected
last
.
• If
both
USB 1
and
USB 2
host ports are connected, and one USB host port is disconnected, then the AT-
OME-MS42 will automatically switch to the opposite USB host port.
5.
Follow USB configuration is complete.
Manual
This mode provides manual selection of the USB host port to be used.
1.
Connect the host computers to the USB host ports, as desired. Note that it is not required that both USB host
ports be connected to host devices.
2.
Login to the web server. Refer to
Introduction to the Web Server (page 51)
.
3. Click
USB
in the menu bar.
4. Click the
Manual
radio button.
5.
Click the drop-down list, under the Manual radio button, to select the desired USB port.
6. Manual USB configuration is complete.
