AT-OPUS-RX41
40
Configuration and Management Interfaces
HDBT page
HDBaseT Zone
The AT-OPUS-RX41 has only a single HDBaseT input. Therefore, this drop-down list is disabled.
Start
Click the
Start
button to begin the HDBaseT testing process. During testing, the button text will change to “Stop”.
Click the
Stop
button to halt the HDBaseT testing process. HDBaseT testing can be performed at any time, while
the unit is powered. Refer to the instructions on this web page for information on how to interpret the Bit Error Rate
(BER) and cable test results.
TX Version
The version of the Valens chip on the transmitter.
RX Version
The version of the Valens chip on the receiver.
TMDS Clock
Displays the pixel clock speed. If no source is connected, then this field will display as “None”.
Cable length (Estimated)
This field indicates the approximate length of the Ethernet cable connected between the HDBaseT port on the AT-
OPUS-RX41 and the receiver. If the cable length is less than 15 feet, then this value will be displayed as 0 (zero).
Video Quality (Video BER)
The Bit Error Rate (BER). This field displays either PASS or FAIL during a test.
Cable Quality Pair (A, B, C, D)
Each of these fields will display either PASS or FAIL during a test.
