AT-OME-SW32
12
Installation
Connection Instructions
IP Modes
1.
Connect HDMI and USB-C Sources to the inputs.
2. Connect up to two HDMI displays to the outputs.
3.
Connect the 2CH analog AUDIO OUT ports to a DSP, or audio amplifier (e.g. AT-GAIN-60).
4.
*Optional* For control, connect to the 3-pin captive screw RS-232 port.)
5.
*Optional* Connect a network switch to the LAN port, for IP control, system configuration, or Ethernet routing.
6.
Connect the included DC 24V power supply to the power port.
7.
Connect the included IEC power cord from the power supply to a compatible power outlet.
Static
If no DHCP server is available, or a static IP is required, the SW32 can be set to static IP mode using the IP reset but
-
ton.
•
Press and hold the
IP RESET
button for 10 seconds to switch to static IP mode, the LED will blink 2 times when
it goes into Static IP mode. In this mode, the AT-OME-SW32 will be set to the following:
IP address: 192.168.1.254
Subnet mask
255.255.0.0
Gateway: 192.168.1.1
•
To switch back to DHCP, press and hold the IP reset button for 10 seconds. The LED will blink 4 times when suc
-
cessfully put into DHCP mode.
DHCP
By default, the AT-OME-SW32 is set to DHCP mode. In this mode, when the AT-OME-SW32 is connected to the
Local Area Network (LAN), it will automatically be assigned an IP address by the DHCP server (if available).
