Atlas SWC-500, Installation & Operating Manual, Page: 5 / 11

5
Introduction
LOCATION : When choosing a location for
your spray wash cabinet, consider the
following factors:
The spray wash cabinet is designed to clean
parts with a re-circulated detergent and water
● The unit will generate steam. Make
solution. The spray wash cabinet cleans with sure steam will have no adverse
a combination of temperature, pressure, and affects in the area surrounding the
the chemical action of the detergent. The machine.
spray wash cabinet includes an oil skimmer
● Everyday use will result in liquid
to prolong the life of the cleaning solution. Spilling on the floor around the
The simple controls and operation are machine. Consider the use of traction
Designed to make the unit easy to operate. mats and avoid placing the machine in
high traffic areas.
● Allow access for service and utility
connections.
Installation
● Place on a level site.
ELECTRICAL : All electrical requirements
are listed on the identification plate on the
machine. The wiring diagram is inside the
control box. Have your electrician install all
suitable wiring and breaker/disconnect box
necessary. Do not modify power cord
installed on the unit. Once power is installed
have your electrician check motors for
proper rotation but do not turn on heating
elements at this time.
DRAIN CONNECTION : A 2 ″ drain is
located on the unit.
Make sure you have ready access to a
water source. You will be adding water to
the tank on a daily basis.
Detergent Selection
Upon receiving your spray wash cabinet
inspect for an visible damage from shipping.
If any damage is found, make notation on
your bill of lading and contact your freight The manufacturer does not warranty this
carrier. Follow your freight carrier’s spray wash cabinet against rust. Rust will
procedure for handling damage. occur if the proper detergent is not used,
if start-up procedure is not followed, or if
If no damage is found, remove all packaging your machine is not used on a regular basis.
material from the machine being careful not If not regularly used oil should be used on
to damage the casters on the unit. the inside of the machine. Rust can also
occur if you use D.I.water for rinsing.
Open the door to the unit and unpack all
parts and packing materials inside.