1/2
AtlasSound.com
TELEPHONE: (800) 876-3333
FAX (800) 765-3435
©20
10
Atlas S
ound L
.P.
All rights reserved.
Atlas S
ound is a trademark of
Atlas S
ound L
.P.
All other trademarks are the proper
ty of their respecti
ve owner
s.
All specs are subject to c
hange without notice.
ATS0
02960 R
evE 7/1
2
GSS-G & GST-G
Garden Speaker
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
Key Features
•
Downward Firing Speaker Will Not Collect Dust or Condensation
•
Rugged Construction Can Support Up To 250 lbs
•
Easy Bayonet Attachment of Head Unit To Base, Enables Installation
of Base During Excavation and Installation of Head Unit After
Landscaping Has Been Completed
•
Switch Selectable 70V Input or Direct 8
Ω
Input (Transformer Bypass)
•
Easy Conduit Installation in Tall and Short Base With Dedicated
Mounting Pads
•
Speaker Protected By Triple Layer Grille
•
Short Base (GSS-G) has Drill Points for 4" Square, 2-Gang EO Box, or
1-Gang Box Mounting to a Deck or Slab
Instructions
To Install GST-B Tall Base Unit:
1. Make sure you have a path to bury wire connected to speaker.
2. Dig a hole 8" deep x 30" diameter.
3. Run wire to hole.
4. Attach conduit or gland nut to flats on base.
5. Bring in wire and leave sufficient cable for adequate service loop
(minimum 18") to reach head unit.
6. Fill base with clean dirt or sand to within 2"-3" of top for optimum
bass performance.
7. Cover with provided temporary lid and attach with provided
1" screws if head unit is not to be attached immediately.
8. Back fill dirt to base. Top of base should be 2" – 3" above ground.
To Install GSS-G Short Base Unit:
If Using an EO Box:
1. Install 1-Gang, 2-Gang, or 4" x 4" box flush to mounting surface.
2. Cut out scribed line on bottom of base for 1- or 2-gang box.
3. Drill appropriate holes in base (outer 4 holes for 4" x 4", inner 4 for
2-gang, or 1 set of 2 inner for 1-gang).
4. Install wiring in box.
5. Set base on box and attach with screws.
If Using Conduit:
1. Mount base to surface with appropriate screws through the base
bottom.
2. Attach conduit and bring in wire. Provide for surface loop
(minimum 18").
3. Cover with provided temporary lid and attach with provided 1" screws
if head unit is not to be attached immediately.
GST-G
Tall Base
GSS-G
Short Base