OWNER’S MANUAL
AtlasSound.com
1601 JACK MCKAY BLVD. • ENNIS, TEXAS 75119 U.S.A.
TELEPHONE: (800) 876-3333 • FAX (800) 765-3435
©2008 Atlas Sound LP. All rights reserved.
Atlas Sound is a trademark of Atlas Sound LP. Printed in China.
ATS003211 RevA 8/08
9
Specifications are subject to change without notice
ECS-3
5.
Pull Out Light Dimmer Switch – The Pull Out Light can be turned “On” or “Off” by this
switch. There are also two brightness settings.
6.
AC Mains Function Display
7.
AC Mains Voltage Display – This display will illuminate when the AC Mains power
cord is
plugged into an AC source.
Note: the display has a 1.5% tolerance.
8.
Sequence Indicator – There are three green LED active sequence outlet indicators
labeled “SEQ 1”, “SEQ 2” and “SEQ 3”. Their sequence timing is set for 3 seconds between
Sequence 1-2 & 2-3 while in “On” mode, and Sequence 3-2 & 2-1 during “Off” mode. When
the LED is illuminated, the corresponding AC outlet on the rear of the chassis will be active or
“Live”. Turned “On”, the order the trigger sequence is “SEQ 1, SEQ 2, SEQ 3”. Turned “Off”, it
is “SEQ 3, SEQ 2, SEQ 1”.
9.
AC Mains Wiring Polarity Fault Indicator – The Red LED will illuminate if the AC mains
Power Cord is plugged into an AC Mains outlet that is wired incorrectly, such as when the AC
Hot and the AC Neutral are wired backwards.
10.
AC Mains Breaker Indicator – This Red LED will illuminate if the maximum unit current draw
is exceeded. The breaker rating is 15A, but will handle higher peaks for a short period of time.
The LED will illuminate until the AC Mains Breaker is reset.
11.
AC Fault Indicator – Although the Dual Clamping Suppression (DCS) circuit virtually assures
protection from most transient voltage spikes and surges. Nature has a way of occasionally
creating electrical forces that are beyond the capabilities of any device to absorb without
some degree of damage. In the rare instance that this occurs and the DCS circuit has been
6
12
11
10
9
8
7