OWNER’S MANUAL
AtlasSound.com
1601 JACK MCKAY BLVD. • ENNIS, TEXAS 75119 U.S.A.
TELEPHONE: (800) 876-3333 • FAX (800) 765-3435
©2008 Atlas Sound LP. All rights reserved.
Atlas Sound is a trademark of Atlas Sound LP. Printed in China.
ATS003211 RevA 8/08
11
Specifications are subject to change without notice
ECS-3
Rear Panel Features
1.
AC Mains Input – Connect the 9' (3 m) power cord to a 15A 120VAC outlet to
provide power
to the ECS-3.
2.
Sequence 1 AC Outlets – The three AC outlets are “Live” when the Sequence 1 section
is activated. These outlets are recommended for products such as Computers, Modems,
Routers, DSP Processors, Cable/SAT, DVD, or CRT TV’s. These outlets have a special
filter circuit that is optimized to reduce interference to your Digital and Analog components.
The total maximum draw for this sequential section is 10A and the total current draw for the
ECS-3 is 15A.
Note: It does not harm high current audio components to be connected to the
Sequential Section 1 digital filter outlets.
3.
Sequence 2 AC Outlets – The two AC outlets are “Live” when the Sequence 2 section is
activated. These outlets are recommended for Analog and Digital type products such as
Audio Receivers, Tape Decks, Mixers, or Video Equipment. These outlets have a special
filter circuit that is optimized to reduce interference to your analog type components. The total
maximum draw for this sequential section is 10A and the total current draw for the ECS-3 is
15A.
Note: It does not harm high current audio components to be connected to the Sequential
Section 2 filter outlets.
4.
Sequence 3 AC Outlet – The single high current non filtered AC outlet is “Live” when
Sequence 3 section is activated. This outlet is designed to deliver maximum current to power
hungry components like amplifiers and projectors. It does not harm low power consuming
components when connected to the Sequential Section 3 Analog filter outlets. If more high
power outlets are needed or if 15A is not enough current to support your power requirements
you can use the 24VDC trigger to activate an additional power outlet such as the ECM-20SH.
Contact Atlas Sound for AC outlet options.
5.
XLR Light Socket – A 12VDC XLR light socket is to provide power for the optional
ECS-GNL light.
6 5
2
3
4
7
1