1/2
AtlasSound.com
TELEPHONE: (800) 876-3333
FAX (800) 765-3435
©2009
Atlas
Sound
L.P
.
All
rights
reserved.
Atlas
Sound
is
a
trademark
of
Atlas
Sound
L.P
.
All
other
trademarks
are
the
property
of
their
respective
owners.
All
specs
are
subject
to
change
without
notice.
A
TS002960
RevC
1/09
ATS100 Series
Garden Speakers
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
Key Features
•
Downward Firing Speaker Will Not Collect Dust or Condensation
•
Rugged Construction Can Support Up To 250 lbs
•
Easy Bayonet Attachment of Head Unit To Base, Enables Installation
of Base During Excavation and Installation of Head Unit After
Landscaping Has Been Completed
•
Available in 70.7V or 8
Ω
Versions
•
Easy Conduit Installation in Large and Small Base With Dedicated
Mounting Pads
•
Speaker Protected By Triple Layer Grille
•
Small Base (ATS100GS) has Drill Points for 4" Square, 2-Gang EO
Box, or 1-Gang Box Mounting to a Deck or Slab
ATS100 Series Instructions
To Install Large Base:
1. Make sure you have a path to bury wire connected to speaker.
2. Dig a hole 8" deep x 30" diameter.
3. Run wire to hole.
4. Attach conduit or gland nut to flats on base.
5. Bring in wire and leave sufficient cable for adequate service loop
(minimum 18") to reach head unit.
6. Fill base with clean dirt or sand to within 2"-3" of top for optimum
bass performance.
7. Cover with provided temporary lid and attach with provided
1" screws if head unit is not to be attached immediately.
8. Back fill dirt to base. Top of base should be 2" – 3" above ground.
To Install Small Base:
If Using an EO Box:
1. Install 1-Gang, 2-Gang, or 4" x 4" box flush to mounting surface.
2. Cut out scribed line on bottom of base for 1- or 2-gang box.
3. Drill appropriate holes in base (outer 4 holes for 4" x 4", inner 4 for
2-gang, or 1 set of 2 inner for 1-gang).
4. Install wiring in box.
5. Set base on box and attach with screws.
If Using Conduit:
1. Mount base to surface with appropriate screws through the base
bottom.
2. Attach conduit and bring in wire. Provide for surface loop (minimum
18").
3. Cover with provided temporary lid and attach with provided 1"
screws if head unit is not to be attached immediately.
Large Base
Small Base
Head Unit