Installation
30
PVL14OF-EXT
7.10.1
Anchoring Rear Columns
• Move a rear column towards the rear beam until the sliders contact the
back of column. Center the beam in the column.
• Using the base plate as guide, drill each hole in the concrete approximately
120mm deep with the rotary hammer drill D.16.
• Assemble the washers and nuts on the anchors then tap into each hole
with a hammer until the washer rests against the base plate. Be sure if
shimming is required, enough threads are left exposed.
• If shimming is required, insert the shims as necessary around the anchor
bolts. Check the columns for plumb. Re-shim if necessary
• With the shims and anchor bolts in place, tighten by securing the nut to
the base.
• Repeat the above procedures for another column.
7.10.2
Anchoring Front Columns
• If necessary, readjust the runways until the diagonals are equal.
• Repeat the same procedures above for rear columns to anchor the front
columns.
7.11 Installation Of Power Unit
• Attach the power unit onto the bracket on the
power side column.
• Secure it using M8X25 screws, M8 nuts and the
washers.
• Make sure to keep the power unit clean.