©20
18
Atlas S
ound L.P
. The
Atlas
“Circle
A”
, S
oundolier
, and
Atlas S
ound are trademarks of
Atlas S
ound L.P
. IED is a registered trademark of Inno
vati
ve Electronic Designs LLC.
All Rights R
eserved.
All other trademarks are the proper
ty of their respecti
ve owner
s.
All specs are subject to c
hange without notice.
A
TS0
05842 R
evA 9/1
8 PN 493536
2/8
AtlasIED.com
TELEPHONE: (800) 876-3333
FAX (800) 765-3435
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
Misc Settings
1. Service Button - The only push switch located on the main circuit board.
• Press 1 sec - The current IP address will be spoken (in English) through the 8
Ω
loudspeaker
• Press 10 sec - Factory reset
• Press and hold while applying power - Hold the button until the Status LED on the circuit board starts blinking rapidly to perform a factory
reset without any servers present
Note:
To access PCB remove back top panel of the speaker enclosure.
Installation Via Mounting Cables (Included)
General considerations and hardware recommendations
CAUTION:
A fall from almost any height could result in serious injury or death. Assure that the speaker is firmly mounted to an object that can handle
the weight of the IP-PM8GD. The mounting surface the IP-PM8GD is being attached to should be able to handle five or more times the weight of the
IP-PM8GD.
The hardware employed must be safely and securely attached both to the speaker and the structure in question, using only the mounting holes. A
general rule for soft surface installations (wood beams) is to multiply the corresponding working load limit by 75%: the result will be approximate
working load strength. Use thread locking compound for all installations.
CAUTION:
Mounting the IP-PM8GD may require two people.
When in doubt contact a qualified structural/mechanical engineer for approval of the mounting materials and methods.
1. Rotate the top cover counterclockwise and pull up to remove. (Figure 1 and 2)
2. Locate suitable support structure in the area the speaker is to be installed.
3. Route the bare end of the main support cable though the included clamp, then around the mounting structure, and back through the clamp.
(Figure 3 and 4)
4. Adjust the cable length in the clamp so that the eyelet end of the cable is at the final height above the floor. (Figure 5)
5. Route the eyelet end of the main support cable through the top cover of the IP-PM8GD. Attach the included carabiner clip to the eyelet and the
large mounting hole on the back of the IP-PM8GD. (Figure 6)
6. Repeat steps 1 - 4 for the safety cable and attach it to one of the outer mounting holes on the support plate of the IP-PM8GD using the included
mounting screw. (Figure 6)
7. Route the Ethernet cable through the top cover and connect to the RJ-45 Connector.
8. Position the top cover over the side cover screws and rotate the cover clockwise to align the top cover mounting screw holes. Install the 3
mounting screws which are located in the hardware bag. Then tighten the side cover screws.
9. Slide the top hole plug over the main support cable, safety cable, and Ethernet cable using the opening on the side of the plug. Then slide the plug
down the cable and into the top cover hole. (Figure 7 and 8)
Note:
If the speaker is being installed outdoors, seal plug with RTV silicone to prevent moisture from entering speaker.