Atlas Copco XRHS 1150 CD4 C3 WUX, Instruction Manual, Page: 31 / 106

- 31 -
TOWING INSTRUCTIONS WAGON
1. Attach the compressor to the towing vehicle.
2. Connect the brake pressure lines (when equipped
with ABS).
3. Move hand brake lever (1) in the direction of the
arrow till stop and connect the breakaway chain
(2) to the towing vehicle.
Never move the compressor with air hoses connected
to the air outlet valves.
When equipped with ABS:

Before moving the unit without connecting the
brake pressure lines, pressure has to be released
from the ABS brake system by pushing button (3).

If the ABS vessel is under pressure it is possible to
put pressure back on the brakes by pulling button
(3).
TOWBAR LEVELLING WAGON
The towbar of the wagon is equipped with an
adjustable spring loaded levelling device.
To adjust:
1. Slide back the rubber bellows (1).
2. Turn the nut (2) clockwise to increase the spring
load for lifting the towbar; turn the nut (2) counter
clockwise to decrease the spring load for lowering
the towbar.
3. Slide the bellows (1) over the nut.
Before towing the compressor, ensure
that the towing equipment of the vehicle
matches the towing eye. The height of
the towing device of the vehicle must be
815 - 845 mm (31.8 - 33 in).
Before moving the compressor, switch it
off.
(1)
(2)
When towing a compressor equipped
with tandem axles, take care that the
angle between compressor and towing
vehicle does not exceed 10° (see picture)
10˚
10˚
+
-
(1)
(2)