Atlas Copco XAS 185 KDU T4F HOP, Instruction Manual

Page: 51 / 62

- 51 -
AIR RECEIVER
The air receiver is tested according to official standards.
Regularly have inspections carried out in conformity with
local regulations.
SAFETY VALVE
Following checks must be carried out:
– a check of the opening of the lifting gear, twice a year.
This can be done by lifting the ring or lever.
– a check of the set pressure once a year according to the
local regulations. This check cannot be done on the
machine and must be carried out on a proper test bench.
FUEL SYSTEM
Fuel filter
Replacing the filter element:
1. Unscrew the final filter element from the adapter
head(1).
2. Clean the adapter head (1)sealing surface. Lightly oil
the gasket of the new element and screw the latter
onto the header until the gasket is properly seated,
then tighten with both hands.
3. Do not fill with fuel before assembling new filter.
Filling the fuel filter (2)introduces dirty (unfiltered)
fuel to the injectors.
4. After replacing the final filter’s element, prime fuel
system with fuel pump. Pump activates in accessory
key position.
5. Check for fuel leaks once the engine has been
restarted.
WATER SEPARATOR WITH PRIMARY PUMP
Fuel pre filter
All adjustments or repairs are to be done by
an authorized representative of the valve
supplier.
1. Primary pump
2. Water separator
3. Drain