Atlas Copco HiLight H4 Kd ESF, Instruction Manual

Page: 54 / 94

- 54 -
PAROIL provides wear protection under extreme
conditions. Powerful oxidation resistance, high
chemical stability and rust- inhibiting additives help
reduce corrosion, even within engines left idle for
extended periods.
PAROIL contains high quality anti-oxidants to
control deposits, sludge and contaminants that tend to
build up under very high temperatures.
PAROIL's detergent additives keep sludge forming
particles in a fine suspension instead of allowing them
to clog your filter and accumulate in the valve/rocker
cover area.
PAROIL releases excess heat efficiently, whilst
maintaining excellent bore-polish protection to limit
oil consumption.
PAROIL has an excellent Total Base Number (TBN)
retention and more alkalinity to control acid
formation.
PAROIL prevents Soot build-up.
PAROIL is optimized for the latest low emission
EURO -3 & -2, EPA TIER II, III and IV engines
running on low sulphur diesel for lower oil and fuel
consumption.
PAROIL Extra
PAROIL Extra is a synthetic ultra high performance
diesel engine oil with a high viscosity-index. Atlas
Copco PAROIL Extra is designed to provide
excellent lubrication from start-up in temperatures as
low as -25°C.
PAROIL E
PAROIL E is a mineral based high performance
diesel engine oil with a high viscosity-index. Atlas
Copco PAROIL E is designed to provide a high level
of performance and protection in standard ambient
conditions as from -10°C.
5.7.3 Engine coolant specifications
The use of the correct coolant is important for good
heat transfer and protection of liquid-cooled engines.
Coolants used in these engines must be mixtures of
good quality water (distilled or de-ionised), special
coolant additives and if necessary freeze protection.
Coolant that is not to manufacturer's specification will
result in mechanical damage of the engine.
The freezing point of the coolant must be lower than
the freezing point that can occur in the area. The
difference must be at least 5°C (9°F). If the coolant
freezes, it may crack the cylinder block, radiator or
coolant pump.
Consult the engine's operation manual and follow the
manufacturer's directions.
Litre
US
gal Imp
gal
cu.ft
Order
number
can 5 1.3 1.1 0.175 1630 0135 00
barrel 20 5.3 4.4 0.7 1630 0136 00
Litre
US
gal Imp
gal
cu.ft
Order
number
can 5 1.3 1.1 0.175 1615 5953 00
can 20 5.3 4.4 0.7 1615 5954 00
barrel 209 55.2 46 7.32 1615 5955 00
Never remove the cooling system filler
cap while coolant is hot.
The system may be under pressure.
Remove the cap slowly and only when
coolant is at ambient temperature. A
sudden release of pressure from a
heated cooling system can result in
personal injury from the splash of hot
coolant.
It is strongly recommended to use
Atlas Copco branded coolant.
Never mix different coolants and
mix the coolant components outside
the cooling system.
00_00_HiLight H4_EN.book Page 54 Monday, April 18, 2016 2:10 PM