♦
Inject 4 to 6 strokes of cutter grease per lubrication
nipple.
A
A
♦
Place the grease gun on the lubrication nipples of
the cutter jaw (single) (B).
♦
Inject 4 to 6 strokes of cutter grease per lubrication
nipple.
♦
Place the grease gun on the lubrication nipples of
the cutter jaw (double) (C).
♦
Inject 4 to 6 strokes of cutter grease per lubrication
nipple.
B
C
Lubricating the four point bearing
Lubrication interval: once a month.
♦
Place the hydraulic demolition cutter vertically on
the cutter jaws.
♦
Secure the carrier such that it cannot move
unexpectedly.
♦
Only use cutter grease for lubrication.
♦
Place the grease gun on the lubrication nipple (A)
of the four point bearing.
♦
Inject 4 to 6 strokes of cutter grease per lubrication
nipple.
A
A
Checking the hydraulic
demolition cutter and adapter
plate for cracks
♦
Secure the carrier such that it cannot move
unexpectedly.
♦
Check all the hydraulic demolition cutter and
adapter plate load-bearing parts and welds for
cracks prior to every shift.
♦
Ensure repair or refinishing in good time to prevent
greater damage.
Checking hydraulic demolition
cutter for wear
♦
Secure the carrier such that it cannot move
unexpectedly.
WARNING Parts of the body or whole bodies
may be sheared or crushed
Cutter jaws may close unexpectedly and shear or
crush parts of the body or whole bodies.
►
Ensure that there is nobody between the cutter
jaws.
© 2015 Construction Tools GmbH | No. 3390 5141 01 | 2015-11-16
Original instructions
46
CC 1700 U, 1700 S
MAINTENANCE
