27
1.5 Connect the loads
First, connect the UPS with the AC Mains, then plug the loads into the output
connectors on the rear of the UPS (there are 4 IEC). To use the UPS as a master
“On/Off” switch, make sure that all of the loads are switch “On”. Connect a single
line telephone into the RJ-11 telephone surge protection “IN” jack on the back of
the UPS. Connect from the “OUT” jack with telephone cable to a fax modem.
Connect the supplied interface cable to the USB computer interface port on the
back of the UPS. Connect to the computer. Download and install software from
. See software document for installation instruction.
NEVER connect a laser printer or scanner to the UPS unit.
This may cause the damage of the unit. These UPS outlets
provide battery power and surge protection to the
equipment when utility voltage is outside acceptable limits.
