31
This section describes the configuration required by LAN-attached PCs that
communicate with the Wireless Multi-Function Access Point, either to configure the
device or for network access. These PCs must have an Ethernet interface (or
wireless adapter) installed properly,
be connected to the Wireless Multi-
Function Access Point either directly or through an external repeater hub
,
and have TCP/IP installed and configured with a fixed IP address that must be in
the same subnet of the Wireless Multi-Function Access Point. The default IP address
of the Wireless Multi-Function Access Point is
192.168.1.252
and subnet mask is
255.255.255.0.
First of all, please check your PC’s network components. The TCP/IP protocol stack
and Ethernet network adapter must be installed. If not, please refer to MS Windows
related manuals.
Following next steps you can make operating NetFly in short time using PCs in
DHCP mode.
Before you configure this Wireless Multi-Function Access Point, you need to know
the following default settings:
Username:
admin
Password:
atlantis
IP LAN address: (
192.168.1.252
), Subnet Mask (
255.255.255.0
)
DHCP Server:
Enable (192.168.1.50 - 192.168.1.99)
Mode:
Repeater
Channel:
Auto
Wireless SSID(Extended Interface):
A02-AP5-W300N+
Wireless Security:
WPA2-PSK (AES),
Password:
NetFlyAP5
1.7 TCP/IP Configuration
Configuring PC (Windows 2000)
Go to
Start / Settings / Control Panel
. In the Control Panel, double-click on
Network and Dial-up Connections
.
Double-click
LAN Area Connection/Wireless
.
In the
LAN Area Connection/Wireless
Status window, click
Properties
.
Select
Internet Protocol (TCP/IP)
and click
Properties
.
Select the
Obtain an IP address automatically
and the
Obtain DNS
server address automatically
radio buttons.
Click
OK
to finish the configuration.