Atlantis NetFly AP4 WN, Manual

Page: 14 / 90

14
This section describes the configuration required by LAN-attached PCs that
communicate with the Wireless Multi-Function Access Point, either to configure the
device or for network access. These PCs must have an Ethernet interface (or
wireless adapter) installed properly, be connected to the Wireless Multi-Function
Access Point either directly or through an external repeater hub or by wireless, and
have TCP/IP installed and configured with a fixed IP address that must be in the
same subnet of the Wireless Multi-Function Access Point. The default IP address of
the Wireless Multi-Function Access Point is 192.168.1.2 and subnet mask is
255.255.255.0. For example, when the default network address of the default IP
address of the AP is 192.168.1.1, then the manager PC should be set at 192.168.1.x
(where x is a number between 5 and 254), and the default subnet mask is
255.255.255.0.
Please follow the steps below for PC‟s network environment installation. First of all,
please check your PC‟s network components. The TCP/IP protocol stack and
Ethernet network adapter must be installed. If not, please refer to MS Windows
related manuals.
Before you configure this Wireless Multi-Function Access Point, you need to know
the following default settings:

Username: admin

Password: atlantis

IP LAN address: ( 192.168.1.2 ), Subnet Mask ( 255.255.255.0 )

DHCP Server: disable

Mode: Client Bridge
When NetFly AP4 works as Access Point/Bridge the IP
192.168.1.1.
1.7 TCP/IP Configuration
Windows 2000

Go to Start / Settings / Control Panel . In the Control Panel, double-click
on Network and Dial-up Connections.

Double-click LAN Area Connection.

In the LAN Area Connection Status window, click Properties.

Select Internet Protocol (TCP/IP) and click Properties.

Select Use the Following IP Address (EG IP= 192.168.1.5 and subnet
Mask= 255.255.255.0 ).

Click OK to finish the configuration.