Figure 1.
1½” T
1½” x 1”
Reducing
bushing
3
Brass
Body
Disc Lamp Gasket
Lens
Slot
Brass Lens Ring
SOLW2:
Maintenance
Replacement LED Bulbs are available for SOL Spotlights and Compact Spotlights. To loosen and
tighten the brass lens ring on SOL Spotlights and Compact Spotlights, use the included key.
Simply place the key in the slots on the brass lens ring to loosen or tighten. Ensure that all
components are installed correctly after servicing. Inspect the silicone gaskets for defects and
proper placement before re-assembling. Ensure that the lens ring is tightly secured before
submersing the fixture.
Brass Body
Brass Lens Ring
LED Bulb
Gasket
Lens
Slot
SOLW6:
SPOUT LIGHT - SOLWSL2
Installation
The Spout Light can be installed behind a wall, shining through a wall spout (see Figure 1) or
under a core-drilled stone or pot (see Figure 2). The light is designed to be installed in any tee
that has 1” female threads. If the tee is larger than 1”, a reducing bushing with 1” female threads
will be needed. Install the light into the tee, with the light facing the water outlet. Apply teflon
tape, paste or RTV silicone to the threads of the light and thread the light into the fitting. Do not
use the cord to twist in the light or allow it to become twisted when tightening. The spout light
cannot transmit light through sweeps or around corners. There must be a direct path for the
light to be transmitted. The use of rigid PVC plumbing (1” diameter or greater) is highly
recommended for the best results.
Figure 2.
¾” KF tubing
1” Female
threaded T