Atlanta Attachment Company 4300AC, Technical Manual & Parts Lists

Page: 39 / 168

Technical Manual & Parts Lists
32
2.7.3.- Setting Up The Machine To Make Borders
If you see a message “Border Slack Warning” on the screen, open the prefeed rollers and pull back the
slack border material until the prefeed loop eye is uncovered and then close the rollers.

On the “READY – NEW ORDER” screen, press the “EDIT NEW ORDER” button.

On the “EDIT ORDER” screen, press the “Border Style” button.

Select the style number of the border style that needs to be run. If the style number is not known,
press the “Style List” button on the “EDIT ORDER” screen to see a list of all the current styles
programmed in the machine.

After selecting the style needed, press the “ENTER” button on the “SELECT STYLE” screen.

Select the quantity of borders needed for the order using the “Quantity” button on the “EDIT
ORDER” screen and then press the “EXIT” button on the bottom of the screen.

Press the “START” button on the “READY – NEW ORDER” screen to run the current border
order.
When the machine runs out of material it stops, and will display a possibility of two screens:

If there IS enough material to finish the current border, an “Out of Border Material” screen is
displayed with a “Finish Border” button to allow the operator to press it and finish making the
current border. After this the “Splice on New Roll” screen comes up which tells the operator
how to properly splice on a new roll.

If there IS NOT enough material to finish the current border, a different “Out of Border
Material” screen is displayed and the prefeed will back up approx. 10”. This allows the operator
to pull back the material and splice on a new roll of material at the roll holder or, to save
material, splice on a new roll the same way it was described in the Border Loading Procedure.
From
the
library
of:
Diamond
Needle
Corp