Atlanta Attachment Company 3200PC, Technical Manual & Parts Lists, Page: 15 / 72

Technical Manual & Parts Lists
10
Electrical / Pneumatic Setup
Electrical: 220 VAC, 15amp, 50/60 Hz Single Phase
Pneumatic: 80 PSI, 5 SCFM avg.
Set the low pressure switch to 60 PSI.
Sewing Heads: Juki Lockstitch DNU1541-7
RPM: 1800
Machine Setup
 Position the machine in a desired location on a sound and reasonably level floor.
 Make sure that there is sufficient lighting over the machine.
 Remove all packing material.
 Adjust the jack screws so that the casters are about 1/8” off the floor.
 Connect electrical power and compressed air as specified above and in accordance to local
codes.
 Open the main control box door in front of the machine. Turn on the ON/OFF circuit breaker
located in the top right corner by pressing the green button. The green light inside the button
should illuminate.
 Turn the main air lock-out valve (red knob before the main pressure regulator) to the ON
position.