Atlanta Attachment Company 1342ZTC, Technical Manual & Parts Lists, Page: 14 / 34

Technical Manual & Parts Lists
10
Parameter Settings
1342ZT Programming Instructions
PARAMETER RANGE VALUE DESCRIPTION
Do this first
***** ****
Perform a master reset before programming, see below
290 5 Mode of operation. MUST SET THIS PARAMETER FIRST!
111 200-9900 rpm 0800 Maximum speed.
134 0-1 0 Soft start enable.
142 0-3 0 Speed status for the seam
161 0-1 1=CCW Motor rotation
182 0-1 0 Reverse motor rotation.
240 052 FLIP/FLOP Input function setting.
270 0-5 1 External handwheel sensor configuration.
271 0-255 108
Number of angular degrees for stopping position other than a full
heelback stop. NOTE: setting is based on a reflective tape length of
1/2".
272 020-255 0410
Drive ratio between motor pulley and handwheel pulley. If handwheel
pulley is smaller than motor pulley, increase this value to slow down
sewing head until measured speed matches speed set with
parameter 111.
310 12 SELECT POWER TRANSISTOR
436 0
Use code "5913". This disables an input that was causing box to
reset itself.
Front panel LED's: Programming Instructions:
LED 1: Off 1. Power on holding down the "P" button till "COD" is displayed.
LED 2: Off 2. Press ">>" once and enter the number "3112"
LED 3: Off 3. Press "E" once and "2.0.0." is displayed. This is a parameter.
LED 4: Off 4. Press "E" again and the value for parameter 200 is displayed.
LED 5: On 5. With the value on the screen, adjust to desired setting.
LED 6: On 6. Press "E" to enter value and continue with parameter setting.
LED 7: On 7. Repeat for other parameters, press "P" once when complete.
LED 8: Off 8. Run sewing head to save parameters before powering down
To Perform Master Reset of Parameters:
1. Power on holding down the "P" button till "COD" is displayed.
2. Press ">>" once and enter the number "5913"
3. Press "E" twice and "093" is displayed.
4. Press "+" once, "094" is displayed.
5. Press "P" to exit programming mode with all default values.
From
the
library
of:
Diamond
Needle
Corp