17
Maintenance / Cleaning / Storage
•
Each time before starting maintenance work:
−
Switch off the motor and pull out the mains plug.
−
Allow the machine to cool down.
−
Wear protective gloves to prevent injury.
When the machine is stopped for purpose of maintenance,
storage or accessory replacement make sure that the
energy source is isolated and the mains plug is
disconnected. Make sure that all movable parts are
stationary and the key (if applicable) is removed. Allow the
machine to cool down before maintenance, adjustment etc.
The cutters will not come to a standstill immediately after
cut-off. Before starting any service work wait until all parts
are stationary.
When performing maintenance operations on the cutting
tool be aware that it can still move due to the start
mechanism even if the motor does not run by the cover
interlocking.
Be sure to have removed any tools from the machine after
completion of service work.
•
Generally garden shredders require little maintenance.
To maintain their efficiency and a long life, observe the
following:
−
Keep vent slits clean and free from obstructions.
−
Check the locking screws (tighten where necessary).
−
Clean the device after shredding.
To clean your product only use a warm moist cloth and a soft
brush.
Never use cleaning agents or solvents. Otherwise the device
may be damaged irreversibly. Plastic parts may be corroded
by chemicals.
−
Do not clean the machine with running water or high-
pressure cleaners.
−
After each operation treat bare metal parts with an
environment-compatible biodegradable spray oil to protect
them against corrosion.
Replace worn and damaged single parts as a whole set to
prevent any unbalance.
Operational faults
Before each fault elimination:
−
Switch off device.
−
Wait for standstill of the garden shredder.
−
Pull out mains plug.
Fault
Possible cause
Removal
Motor does not start.
−
No power supply.
−
Mains cable defective.
−
Upper part of the enclosure not properly
closed (safety shut-off is activated).
−
Retaining basket unlocked
(safety cut-
out device of the retaining basket has
tripped)
−
Check fuses.
−
Have these checked (electrician).
−
Close and bolt down upper part of the enclosure
correctly, remove any dirt present.
−
Lock the retaining basket
Motor hums,
but does not start.
−
Cutters blocked.
−
Capacitor faulty.
−
Switch machine off, disconnect mains plug, and
clean interior of machine.
−
Have machine repaired by manufacturer or
approved company.
Reduced cutting
performance.
Knife edges became blunt.
Turn the knife or replace it with a new set of knives.
Device starts but blocks
under slight load and cuts off
via protective motor switch.
Extension cable too long, or cross-section too
small. Socket too far from mains supply and
cross-section of mains cable too small.
Extension cable at least 1.5 mm², maximum 25 m
long. If a longer cable is used, minimum cross-
section 2.5 mm².
In case of further failures please contact our customer service.
