Manual, Control Module, PROFINET, DL10
Document #9620-20-C-DL10-04
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel: 919.772.0115 • Fax: 919.772.8259 •
C-16
2.3 Tool Module
In addition to providing Tool‑ID and Tool side TSI, the Tool module is a pass‑through for PROFINET
signals and power to downstream equipment. For details, refer to
.
2.3.1 Tool-ID
The Tool module utilizes a rapid communication method to report the Tool‑ID information from
the push button switches to the Master module as soon as the Tool Changer or Utility Coupler is
coupled. Typically the Tool‑ID information is available to the Master within 150 ms from the time
the Tool Changer or Utility Coupler is coupled.
NOTICE:
When a Tool module is not present, the Master module reports an invalid ID
1>0xFFFF.
(5) push button switches are provided on the Tool module for setting of a Tool‑ID number.
If the plastic window and seal above the Tool‑ID switches are removed, ensure the seal and window
are re‑positioned correctly to prevent a leakage path to the module inside.
Figure 2.5—Tool Module, Tool-ID Switch Settings
Decrease (-) Digit
Increase (+) Digit
Set Tool ID to an
Unique 1-Digit Number
for each Tool
Window
(4) M3 Captive
Head Screw
O-ring Seal
SW5 SW1
←
