Manual, Valve Adapters, Single Solenoid
Document #9620-20-C-Jxx Valve Adapters with a Single Solenoid-04
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel: 919.772.0115 • Fax: 919.772.8259 •
C-7
2.4 Valve Adapter Removal for QC-310, QC-313, QC-510, QC-1210
NOTICE:
Depending on maintenance or repair being performed, utilities to modules and Master
plate may need to be disconnected.
Tools required:
5 mm hex key, 4 mm hex key
1. Place the Tool in a secure location.
2. Uncouple the Master and Tool plates.
3. Turn off and de-energize all energized circuits (for example: electrical, pneumatic, and
hydraulic circuits).
4. Remove the control/signal module off the valve adapter (refer to the control /signal module manual
for instructions).
5. Use a 4 mm hex key to remove the (2) M5 socket head cap screws, and use a 5 mm hex key to remove
the (2) M6 socket head cap screws. Lift the valve adapter module off the Tool Changer or Utility Coupler
6. Make sure that the O-rings are retained at the Master side Flat ‘A’ mounting interface.
2.5 Tool Adapter Assembly Installation
Tools required:
5 mm hex key, 4 mm hex key, torque wrench
Supplies required:
clean rag, Loctite
®
222
™
and Loctite
®
242
™
1. Place the Tool in a secure location.
2. Uncouple the Master and Tool plates.
3. Turn off and de-energize all energized circuits (for example: electrical, pneumatic, and
hydraulic circuits).
4. Wipe down the mounting surfaces with a clean rag.
5. Place the Tool adapter assembly on the Tool Changer or Utility Coupler.
6. Apply Loctite
®
242
™
to the supplied M6 socket head cap screws. Use a 5 mm hex key to install the (2)
M6 socket head cap screws and tighten to 89 in-lbs (10.0 Nm).
7. Apply Loctite
®
222
™
to the (2) supplied M5 socket head cap screws. Use a 4 mm hex key to install the
(2) M5 socket head cap screws and tighten to 52 in-lbs (5.9 Nm).
Figure 2.4—Tool Adapter Assembly Installation
Control/Signal
Tool Module
(2) M6 Socket Head
Cap Screws
(2) M5 Socket Head Cap Screws
(2) M6 Socket Head Cap Screws
(9005-20-1192) Tool Adapter Assembly
Tool Change Tool Plate
(QC-310 Shown)
