ATI Technologies Flexdeburr 9150-RC-660-ER, Manual, Page: 44 / 49

Manual, Flexdeburr, RC‑660 Series
Document #9610‑50‑1017‑10
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 USA • Tel: +1.919.772.0115 • Fax: +1.919.772.8259 • www.ati‑ia.com
44
8.
Specifications
Table 8.1
—Specifications
Parameter Rating
Motor Turbine
Motor Part Number 3490‑0001038‑02
Motor Series 210JSL
Idle Speed (RPM) 40,000 (44,000 Max.)
Torque (Max. Power) 0.16 N‑m (1.4 lb‑in)
Power (0.88 hp) @ 40,000 RPM
Weight (without Adapters) 2.2 kg (4.9 lb)
Compensation (Radial) +/‑ 9 mm max., +/‑ 4.5 mm recommended
Compliance Force
(Measured at Collet)
12.8‑45.4 N (2.8–10.2 lb) @ 1.0‑4.1 bar (15–60 psi)
Bur Surface Speed Dependent on Cutter Geometry and Motor Speed
Spindle Air Pressure 6.2 Bar (90 PSI)
Air Consumption (Idle) 9.4 l/s (20 CFM)
Air Consumption (Stall) 17.9 l/s (38 CFM)
Sound Pressure Level
2
78 dBa
Collet Size, Standard
3
1/4" (6 mm) (ER‑11 Type with Large Grip Range)
Rotary Burs
4
Commercial Units Rated 40,000 RPM or Higher
Special Tools
Open End Wrenches (1 Pair Supplied)
7/16” (11 mm) Open End
10 mm Narrow (Only for use with ER11 Collets)
Notes:
1.
Specifications applied to a series of models cover the basic “inch” designs and metric ‑E models.
2. All noise emission measurements were taken under no load idle conditions without a cutting tool.
Because the working environment is unknown, it is impossible to predict the noise that will occur
during a deburring operation.
3. Optional Sizes Available, See Section 7—Serviceable Parts .
4. ATI Can Supply Burs, See Section 4.5.1—Bur Selection .