Manual, Control Module, PROFINET, DL12
Document #9620-20-C-DL12-06
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel: 919.772.0115 • Fax: 919.772.8259 •
C-23
3.8 Setting the Tool-ID
There are (5) push button switches are provided on the Tool module for setting of a Tool‑ID number. Each
Tool must have an unique 5 digit Tool‑ID number.
Tools required: Phillips screw driver
Figure 3.3—Setting the Tool-ID
Decrease (-) Digit
Increase (+) Digit
Set Tool-ID to an
Unique 1-Digit Number
for each Tool
Window
(4) M3 Captive
Head Screw
SW5 SW1
SW5 SW1
1. Loosen the (4) M3 pan head captive screws and remove Tool‑ID window.
2. Use a non‑conductive tool (e.g., plastic stylus) to press on the Tool‑ID push buttons to increase (+) or
decrease (‑) the digit value from 0 to 9. Set the Tool‑ID to the desired unique 5 digit number from 00000
to 99999 for each Tool.
3. Re‑install the Tool‑ID window and tighten the M3 pan head captive screws.
