ATH WH220, User Manual, Page: 7 / 28

© Copyright by ATH-Heinl GmbH & Co. KG, 2017, All rights reserved / Misprint and technical changes reserved / Issue: 2017/10
- 7 -
INSTALLATION
Transport and storage
Always use suitable means for transporting and
positioning the machine and keep attention to the
gravity centre of the machine.
The machine should only be transported with the
original packing.
Width 36cm
Length 66cm
Height 28cm
Storage
temperature
-25 to +55 °C
Weight (gross) 48 kg
Unpacking of machine
Remove the upper cover of the carton and make sure that there were no damages during
the transport.
The packing material of the machine should be stored carefully.
Keep the packing material away from children as it could be dangerous for them.
Place of use
The machine should be kept away from flammable and explosive materials as well as from solar radiation
and intensive light. The machine should also be installed in a well-ventilated place.
The jack must be used on a concrete floor or similar solid flooring.
When selecting the place of usage, besides the soil condition also the guidelines and instructions of the
accident prevention regulations and workplace regulations must be observed.
When using on an intermediate ceiling the capacity must be checked before. Generally, it is recommended
to ask a technical expert when installing on an intermediate ceiling.
It is not allowed to install the machine outside, but only inside, as the machine has no corresponding safety
provisions (IP-protection, zinc coated and so on)
Temperature 4-40 °C
Sea level < 1000 m
Air humidity 50% at 40°C – 90% at 20 °C