® Copyright by ATH-Heinl GmbH & Co. KG, 2019, All rights reserved / Misprint and technical changes reserved / Issue: 2019/02
- 29 -
MAINTENANCE
TO GUARANTEE A SAFE OPERTION OF THE MACHINE THE OPERATOR IS OBLIGED TO MAINTAIN THE
MACHINE REGULARLY.
ONLY AUTHORIZED SERVICE PARTNERS CAN MAKE REPARATION WORKS. THE CUSTOMER IS ONLY
ALLOWED TO MAKE THIS AFTER CONSULTING THE MANUFACTURER.
For maintenance and reparation works the machine must be disconnected from ALL power
supply (main switch off, mains plug disconnected). There must be made precautions for a
reconnection by accident.
Before maintenance and repair, the machine must:
1.
disconnect the machine from ALL supply networks.
-
Disconnect main switch, pull out mains plug
-
Drain compressed air from the system
2.
Appropriate measures must be taken against restarting.
Works on the electrical part of the machine respectively on the supply lines are only allowed
to be done by technicians respectively electrically skilled persons.
Consumables for installation, maintenance and care
Hydraulic oil
Minimum requirement:
Eni PRECIS HVLP-D ART.No.00066018
Summer
(15 ° to 45 °):
HVLP-D 46 (for example: Eni PRECIS HVLP-D)
Winter
(below 10 °):
HVLP-D 32 (for example: Eni PRECIS HVLP-D)
Preservation for ropes, welds, screws, corners, edges and cavities.
Minimum requirement:
Petec Spray translucent - 500 ml Art. No. 73550
Petec Suction cup translucent - 1000ml Art. No. 73510
Petec UBS pistol art. No. 98507
Lubricant for slideways
Minimum requirement:
STORER WHS 2002 White EP high performance grease. Art. No. KPF1-2K-20
Lubricant for bushes, chains, rollers & moving parts
Minimum requirement:
White Ultra Lube, 500 ml aerosol. Art. No. 34403 - WUL - White Ultra Lube
Anchor bolts
Minimum requirement for lifts:
Fischer FIS A M 16 x 200 galvanized
in combination with Fischer Superbond reaction cartridge
Minimum requirement for passenger car tire changer and passenger car / truck balancing machine:
Anchor bolts M8 x 100
Summary of Contents for M72Z
Page 1: ...USER S MANUAL ATH M72Z...
