® Copyright by ATH-Heinl GmbH & Co. KG, 2019, All rights reserved / Misprint and technical changes reserved / Issue: 2019/02
- 18 -
Bead breaking of a tire
Preparation
Before operating the machine check the following points:
-
Checking of oil level, water level and air pressure of the maintenance unit.
-
Checking, if the machine is correctly connected to the power supply.
Screw out the inlet of the wheel valve and let the air completely
escape.
Turn respectively clamp the turntable in such a position so that no
components (cylinder, pneumatic
screwing’s
and so on) can be
touched by the tire.
Now turn the rim so that you can first break the bead of the outer side
of the rim.
Lay now the pressure less wheel lateral on the special rubber pad on
the machine housing.
With the lever, the bead shovel can be put on the outer side of the
tire. For a damage-free mounting the shovel must be positioned
approx. 1 cm away from the rim edge.
Press the pedal for the bead breaker until the tire is dismantled from
the rim, then IMMEDIATELY release the pedal.
Turn the wheel further and repeat the bead breaking process until the
tire is completely dismantled from the rim.
For making the following demounting of the tire easier respectively
gentler for the tire and rim it is recommendable to coat the nascent
tire and rim parts while plunging the bead shovel in sufficiently with a
marketable tire bead lubricant.
Do only use approved lubricants!
Make the same with the second wheel side.
Summary of Contents for M72Z
Page 1: ...USER S MANUAL ATH M72Z...
