■
Curvy line installations
□
When you have to shorten a length of the product, it can be cut at every 60.0 mm.
□
Purchase optional End Cap separately.
Use Aluminum Mounting Bracket, FATD-HA.
1. Securely mount the bracket on the wall using screws and the screw holes.
・
Please use the appropriate screws according to the wall.
2. Put and push the products into the bracket securely.
・
Insert the product ribs securely below the bracket ribs.
*
□
Before cutting the product, ensure the cutting point.
□
Diagonally cut may cause a failure of the product or prevent an attachment of end cap.
□
Once the product is cut out, it can not be repaired.
□
Damages and failures which caused by your cutting are not covered under the warranty.
□
After cutting, cover the cutting point with End Cap (optional).
□
Using without End Cap may cause electrical fault, fuming or fire.
Installation Method
■
Straight line installations
Use Aluminum Rigid Channel, FAS00-11TD.
1. Please cut the channel as needed.
2. Remove the burr after cutting the channel, because the burr may cause damages, electric shock and smoke.
3. Securely mount the channel on the wall using screws and screw holes.
CAUTION
・
Please use the appropriate screws according to the wall.
4. Put and push the product into the channel securely.
■
Use Atex Accessories to install the product.
・
Insert the product ribs securely below the channel Ribs.
■
Do not put the screws on the product directly. It may cause damages.
■
Do not use double sided tape and glue to install the products.
■
・
■
Do not perform the excessive bending or twisting of the lead wires and End Caps. It
may cause the failure and the decline in water resistant performance.
In case of installing the product vertically, it may be slided down. As the right figure, set
the L-shape metal corner brace beneath the product. Do not pinch the leads by the
brace to prevevnt fire.
How to Cut the product at site
5. Attach the Fixing Spring over the product into the groove of the channel, and between the leaf springs of the holder
attached backside the channel.
After attaching the fixed springs, pull them to make sure thery are completely fixed in the channel grooves. Otherwise,
the product may be dropped off from the the channel.
After attaching the fixed springs, pull them to make sure thery are completely fixed in the bracket grooves.
Otherwise, the product may be dropped off from the the bracket.
3. Attach the Fixing Springs over the product into the grooves of the brackets, and between the leaf springs of the holder attached
backside of the bracket.
L Shape Metal
Corner Brace
Enlarged figure of cuttable line
Insert the product ribs below the channnel ribs.
Attach the Fixing springs into the groove of the channel, and between the leaf springs.
Insert the product ribs below the channnel ribs.
Attach the Fixing springs into the groove of the bracket, and between the leaf springs.
Wall
.
Fixing Spring
Fixing Spring
Wall
60.0mm
