Tape Light (RGBW/RGB) Color Installation Manual
We will appreciate for your purchase of 'Tape Light RGB(W) Color'. Please peruse this manual and install correctly and safely.
Installation Guide
Use of PC Rigid Channel
Use of PC Mounting Bracket
(1) Cut the Channel
Please fix the PC Mounting Bracket in the necessary location with screws.
Recommended pitch is 220mm or less
Recommended screws :4.1 Round head screw
Please increase the number of the PC Mounting Bracket
if needed for installation location at the project site.
The product is vertical bending type.
Bending Radius is 30mm vertical.
(2) Remove the burr of the channels after cutting
(1)Please use Atex PC Rigid Channel and Atex PC Mounting Bracket for Accent Tape Light to install.
(2)Please do not put screws on the products directly. It may cause damages.
(3)Please do not use a double sided tape and a glue with the products to install.
(4)Please do not bend the product forward horizontal direction. It may cause the failure.
(5)The Endcap are processed for water resistant or insulation.
Please do not constrict the product to keep the performance.
(6)Please do not perform the excessive bending or twisting of the lead wires.
It will cause the failure and the decline in water resistant performance.
Ver.200305
(4) Install the product into the Channel
①
Please install the product with the diagonal line
toward groove on the channel as the right drawing.
②
After that, please install the products in the channel.
Please do not constrict LED of the product when
installing the product in the channel.
When removing the products from the channel,
please reverse the procedure above.
ZTE2TLRGB(W)
Prohibitions
：
Please do not remove the products from
the channel with excessive tension as the right photo.
It will cause the failure.
Note that the burr may cause damages.
* electrifications * smoke.
(3) Mount the Channel onto the wall
Please mount the PC Rigid Channel on the wall using
screws into the screw hole to properly secure it.
Screw : 4.1 Round head screw
Please cut the PC Rigid Channel as needed because it is not
available to insert the end cap of the product in the PC Rigid
Channel.
The insertion of the Endcap to the PC Rigid Channel may
cause the failure and the damage.
Please have the gap 10-20mm between the Endcap and the
PC Rigid Channel.
Endcap
PC Rigid Channel
PC Rigid Channel
①
➁
Groove on Channel
10
～
20mm
Caution
For Keeping
screws
PC Mounting Bracket
Less than 220mm
