- 11 -
Installation
Installation of the VS481
B
is simply a matter of plugging in the
appropriate cables.
To install the switch, refer to the installation diagram on page 12
as you perform the following steps:
1. Use an HDMI cable to connect the HDMI input port on the
video display device to the HDMI output port on the rear of
the VS481
B
.
2. Use HDMI cables to connect the HDMI output ports on the
source device(s) to the HDMI input ports on the VS481
B
.
Three HDMI input ports are located on the rear of the switch;
the fourth HDMI port is located on the front of the switch.
3. (Optional) If you have an IR receiver*, plug it into the IR
Extension port and place it where the IR remote can reach it.
4. Plug the provided power adapter into an appropriate AC
power source; plug the power adapter cable into the Power
Jack on the VS481
B
.
Note:
To purchase an IR extension cable, contact your dealer
and refer to part 2XRT-0003G.
Installing the RS-232 Controller
To attach a high-end controller (such as a PC) to the VS481
B
’s
RS-232 serial interface, use a serial cable. The end connecting
to the VS481
B
should have a 9-pin male connector. Connect this
to the serial interface on the rear of the VS481
B
. Refer to number
5 on the diagram on page 12.
Note:
To configure the serial port, see page 14.
1. Make sure that the power to all devices you will be
installing has been turned off.
2. Make sure that all devices you will be installing are
properly grounded.
