VS0108HB User Manual
3
Planning the Installation
Required Equipment
1 source device equipped with an HDMI Type-A connector
1 ~ 8 display devices equipped with an HDMI Type-A connector
1 HDMI cable (not exceeding 3 m) to connect the VS0108HB to source
device
1 ~ 8 HDMI cables (each not exceeding 3 m) to connect the VS0108HB to
the display devices
Note:
You can connect a DVI source to the VS0108HB via a DVI to HDMI
adapter.
ATEN strongly recommends that you use high-quality HDMI cables of
appropriate length since this will affect the quality of the audio and video
output. Contact your dealer to purchase the correct table sets.
Optional Equipment
To control the VS0108HB using RS-232 serial commands, prepare the following
equipment:
1 RS-232 controller, e.g. a PC
1 serial cable with a 9-pin male connector
