Chapter 3. Local Operation
25
Default Serial Settings
To use / not use the VM1616T’s Default Serial Settings, do the following:
1. Select
Default Serial Settings
from the
Set IP Port
submenu. The cursor
flashes on the entry.
2. Use the In/Out
dials and turn them clockwise/counterclockwise to select
Yes or No, and press In/Out/Enter to confirm.
Adjust Video Level
Video Gain and Video Compensation can be adjusted for all displays at once,
or for each display individually. To adjust video, do the following:
1. Use the Menu button to access the
Adjust Video Level
page.
2. With the cursor flashing at
Adjust Video Level
, press In/Out/Enter to go to
the
Optimize Video Output Port
page to select the display port(s).
3. Use the In
dial and turn it clockwise (ascending from ALL, L, 1.... 16,
ALL) or counterclockwise (descending from ALL, 16.... 1, L, ALL) to
select the display port(s). This is set to ALL by default.
You are able to select all ports in the installation (ALL), just the local port
(L), or any of the 16 ports individually (1–16). Press In/Out/Enter to
confirm your selection. If you selected L, proceed to the next step.
4. Select
Local Video Output Gain
or
Local Video Output Compensation
,
then cycle through the options to adjust values for the local port.
Options are Stored, Auto, or 0–31. This is set to Stored by default. See
page 27 for storing values.
Note:
If either Gain or Compensation is set to Auto, the other will also set
to Auto automatically.
Adjust Video Level
Adjust Audio Level
Optimize Video Output Port: All
Local Video Output Gain: 31
Local Video Output Compensation: 31
