Chapter 3. Operation
10
Source Switch Pushbutton
Press the Source Switch Pushbutton located on the front panel to switch
among the Auto Switch, HDMI, and VGA input mode
.
RS-232 Commands
You can change the input mode using RS-232 commands. Refer to the table
below for a list of available tasks and the corresponding commands.
Type the corresponding command to execute a task. For example, to enable
automatic switching, type
swmode next
and then press
[Enter]
.
Task
Command
Control
Input
Port
Enable automatic input switching
swmode next
N/A
N/A
Disable automatic input switching
swmode off
N/A
N/A
Set the unit to the HDMI mode
sw
i
01
Set the unit to the VGA mode
sw
i
02
View the current input mode settings
read
N/A
N/A
Note:
Press
[Enter]
to execute a command.
The current input mode setting is also indicated by the Auto Switch, HDMI, and
VGA LEDs.
Source Switch Pushbutton
Auto LED
HDMI LED
VGA LED
