ATEN VanCryst VM3200, User Manual

Page: 63 / 209

Chapter 3. Front Panel Operation
47
Port Selection
Input Port Selection
Use the Input Port pushbuttons to select the Input port you want to configure.
To select which input source displays on each output port, do the following:
1. Press an Input port pushbutton. The Output port LED(s) tied to the said
Input port light up. In the example below, pressing Input port 1 shows it is
tied to Output ports 1 and 2 .
2. To disconnect an Output port from an Input port, press the corresponding
Output port pushbutton.
In the example below, Output port
2 has been disconnected from Input port
1 .
INPUT
OUTPUT
1 2 5 5* 1 1 3 4
1 2 3 4 5 6 7 8
INPUT
OUTPUT 1 2 5 5 1 1 3 4
V + A
9 10 11 12 13 14 15 16
P1
↓
:Next