ATEN VanCryst VE8900, User Manual

Page: 78 / 122

VE8900 / VE8950 / VE8952 User Manual
66
Executing Commands
The following instructions presume command operations using a PC. To
execute commands using ATEN Control Boxes, see
ATEN Control System
User Manual for details. To execute a command, do the following:
1. On a connected PC, open a command prompt as administrator.
2. Depending on the supported command type for your PC, do the following
to connect to your deployment.
 Telnet connections
In the command prompt, type the IP address of any VE8900 / VE8950 /
VE8952 receiver in your setup and use port
23 . For example:
 TCP connections
In the command prompt, type the IP address of any VE8900 / VE8950 /
VE8952 receiver in your setup and use port
9138 . For example:
 RS-232 connections
In the VE Manager, set the IR/RS232 of all VE8900 / VE8950 /
VE8952 receivers to
Manual and select the Command Mode option.
When the connection is established, the message “Welcome to CLI mode”
appears.