51
Chapter 5
Telnet Commands
Remote Terminal Operations
With ATEN PE4104G you can log in remotely from a computer using Telnet
interface that allows system control through a high-end controller or PC.
Telnet
Telnet is a program that connects to a device over a network to provide text-
based management and control. Telnet provides some of the same management
features found in the PE4104G’s web GUI. You can reference the PE4104G’s
web GUI functions by downloading the user manual from our website
(www.aten.com). This can help you as you work your way through the text-
based commands used to control the eco PDU that are discussed in this guide.
Telnet is available on all eco PDUs installed with the latest firmware. You can
log in to the PE4104G via Telnet from any computer connected to the same
network.
Setup
Log in to the PE4104G’s web GUI, go to the
Setup
tab and click
Security
from
the menu bar. Under
Working Mode
, check
Enable Telnet Server
and then
click
Save
at the bottom of the page.
Note:
If the
Enable Telnet Server
option is not available, please download the
latest firmware from our website.
Logging In
To log in to the PE4104G via Telnet, do the following:
1. On your computer, open the start menu and select
Run
. Type:
cmd
