ATEN CS1842, User Manual

Page: 55 / 88

Chapter 6. RS-232 Operation
43
Switch to Next Port
The Switch to Next Port command allows you to switch ports from 01~02 and
02~01 (CS1842); 01~02, 02~03, 03~04, and 04~01 (CS1844).
Note: This command is only supported by CS1842 / CS1844 using firmware
v. 1.1.102 or later.
Use the Formula - to set Parameters - to create a Command .
Formula:
C [Enter]
Parameters:
Switch to Next Port Command
The available formula for the Switch to Next Port command is as follows:
C [Enter]
For example, to switch to from port 1 to port 2, type the following:
sw [Enter]
Command Description
sw Switch Port Command
Enter Description
Enter Enter and send out command