ATEN CS18208, User Manual

Page: 48 / 110

CS18208 / CS18216 User Manual
38
Port ID Display
Duration Determines how long a port ID displays on the monitor after a port
change has taken place. The choices are:
3 Seconds (default) and
Always Off .
Port ID Display
Mode Selects how the port ID is displayed: the port number plus the port
name (
Port Port Name ) (default); the port number
alone ( Port Number ); or the port name alone ( Port Name ).
Scan Duration Determines how long the focus dwells on each port as it cycles
through the selected ports in Auto Scan mode (see
F7 SCAN ,
page 45). Key in a value from 1–255 seconds, then press [Enter] .
Default is 5 seconds; a setting of 0 disables the SCAN function.
Scan-Skip Mode Selects which computers will be accessed under skip mode
(see
F5: SKP , page 43), and Auto Scan mode (see F7: SCAN ,
page 45. Choices are:
ALL - All the ports which have been set accessible (see SET
ACCESSIBLE PORTS , page 40);
QUICK VIEW - Only those ports which have been set accessible
and have been selected as quick view ports (see SET QUICK
VIEW PORTS , page 41);
POWERED ON - Only those ports which have been set accessible
and are powered on;
QUICK VIEW + POWERED ON - Only those ports which have
been set accessible and have been selected as quick view ports
and are powered on. The default is ALL.
Note: The quick view choices only show up on the administrator's
screen, since only he has Quick View setting rights (see SET
QUICK VIEW PORTS , page 41).
Screen Blanker If there is no input from the console for the amount of time set with
this function, the screen is blanked. Key in a value from 1–30
minutes, then press
[Enter] . The default setting of 0 disables this
function. The screen will be blanked in the amount of time set
(count from the moment when OSD is closed)
Hotkey
Command Mode Enables / disables the hotkey command function in case a conflict
with programs running on the computers occurs.
Hotkey Sets the keyboard shortcut for invoking Hotkey Mode (see Hotkey
Setting Mode , page 48). Choices are: [NUM LOCK] + [-] (minus)
(default), and [CTRL] + [F12] .
OSD Language Sets the language used in the OSD. Choices are: English (Default),
German, Japanese, Simplified Chinese, Traditional Chinese,
Spanish, French, and Russian.