ATEN CN8000, User Manual, Page: 27 / 208

13
Chapter 2
Hardware Setup
Mounting
Rack Mounting
For convenience and flexibility, the CN8000 can be mounted on a system rack.
To rack mount the unit do the following:
1. Remove the two original screws from the bottom of the unit (near the rear
of the unit).
2. Using the screws provided with the rack mount kit, screw the mounting
bracket into the CN8000 – as shown in the diagram below.
1. Important safety information regarding the placement of this
device is provided on page 157. Please review it before
proceeding.
2. Make sure that the power to any device that you connect to the
installation has been turned off. You must unplug the power
cords of any computers that have the Keyboard Power On
function.
Phillips hex head
M3 x 8