ATEN ATEN VanCryst VM1600A, User Manual

Page: 151 / 204

Chapter 5. CLI Commands
137
2. The controller’s serial port should be configured as follows:
3. When a session is established with the VM1600A, you can control and
configure the VM1600A via RS-232 commands. For more information on
commands, see
Commands , page 138.
Verification
After entering a command, a verification message appears at the end of the
command line as follows:
 Command OK - indicates that the command is correct and successfully
performed by the switch
 Command incorrect - indicates that the command has the wrong format
and/or values.
RS-232 Protocol
Baud Rate 19200
Data Bits 8
Parity None
Stop Bits 1
Flow Control None