Chapter 7. Device Management
61
Network
The Network page is used to specify the Power Over the NET™ device’s
network environment. The main section is divided into 5 panels. Select the
device you want to configure in the Sidebar, then fill in the information in the
panels according to the information given in the sections that follow.
When you have finished making all of your configuration settings, click
Save
(at the bottom of the page).
Service Ports
As a security measure, if a firewall is being used, the Administrator can specify
the port numbers that the firewall will allow. If a port other than the default is
used, users must specify the port number as part of the IP address when they
log in. If an invalid port number (or no port number) is specified, the Power
Over the NET™ device will not be found.
An explanation of the fields is given in the table below:
Note:
1. Valid entries for all of the Service Ports are from 1–65535.
2. The service ports cannot have the same value. You must set a
different value for each one.
3. If there is no firewall (on an Intranet, for example), it doesn’t matter
what these numbers are set to, since they have no effect.
Field
Explanation
HTTP
The port number for a browser login. The default is 80.
HTTPS
The port number for a secure browser login. The default is 443.
Summary of Contents for Altuscn PN5212
