Configuration
91
© 2019, ATEÏS, member of PAX ProAV Group
T5DF, then press [Play] to start the paging.
o
Stacking paging: If the selected zones are occupied by the source with higher priority and the
user requests a paging, users can pre-record the paging message and temporarily save the
message in DPM-T5/CD-T5DF, then the recorded messages can be played after the paging
with higher priority has ended.
Fail percent: When the selected zones are occupied by the source with higher priority,
users can set the percentage of the occupied zones, if this percentage goes beyond your
setting, the [Stacking Paging] function will be activated.
Wait time: Set the waiting time (countdown timer) of the recorded paging message from
[Stack Paging] function. If the stack paging does not play within the [Wait Time], it will be
automatically canceled.
o
Paging stacking: Pre-record the paging message and play it using the built-in speaker of
DPM-T5/CD-T5DF for confirmation first.
Reset selection after paging: Enable/disable to auto deselect the zones after the paging ends.
5.1.6.1.3.2 Add a DNM2-ETH
Name: The name of DNM2-ETH.
Device: The type of remote. Choose [DNM2-ETH] here.
IP: Select the IP address of this DNM2-ETH from [...] drop-down box.
Method:
o
Dynamic: Dynamically increase/decrease the level of speaker based on the background noise
during the paging.
o
Static: Detect the background noise in the beginning of paging, and use the fixed gain based
on [Over Noise Level] setting to increase/decrease the level of speaker.
Device mount: Select which main controller/secondary unit is connected to the DNM2-ETH.
5.1.6.1.3.3 Add a DGL-MIC
Name: The name of DGL-MIC.
Device: The type of remote. Choose [DGL-MIC] here.