Hardware configuration & operation
77
© 2019, ATEÏS, member of PAX ProAV Group
The DIP switch of device ID is followed by the
binary code with 5 digit (BTQ-SL8), 6 digit
(BTQ-SG8), 4 digit (DPM-MAIN).
The Device ID cannot be repeated. The range of
ID can be set as the table on the right.
DIP switch
BTQ-SL8
1~31
BTQ-SG8
0~63
DPM-MAIN
0~15
Please set the ID of BTQ-SL8, BTQ-SG8 and DPM-MAIN orderly, starting by the first number.
How-to:
1. Set the device ID for BTQ-SL8/SG8 and DPM-MAIN. See the example of BTQ-SL8 as the picture
below, the order (4~0) of the device ID is set as 00101 by the binary code. And the ID will be
converted by the decimal code as 5, that is to say this device will be identified with the ID number
of 5.
BTQ-SL8
2. After the ID setting and the rest of the device hardware wiring are completed, go to
> Device Management > System Size
to build a BOUTIQUE system by adding the number of
controller/secondary units in the same group based on the hardware wiring.
3. Then go to Device Management to check if all the BOUTIQUE units are ''online''.
To identify the connection among the secondary units, each secondary unit has an unique ID.
And the ID must be set orderly based on the Digi-link connection. For example, if the ID of BTQ-
VM8 controller is 1:
1
, then the ID of the first connected BTQ-SL8 unit on BTQ-VM8 will be 1:
2
,
and 1:
3
for the second BTQ-SL8 unit.
4.5
Route BGM sources to zones
Route the BGM (background music) sources such as CD, USB, etc. to the selected zone(s).
The music sources need to be set as "Route Key" mode on web browser first, see
Follow the steps below to route audio source to zones
